亚洲三区在线观看无套内射,无码专区天天躁天天躁在线,自拍 偷拍 日韩,自拍欧美一区二区

High quality hydraulic equipment manufacturers!
TELL:+8613184968882

tailboard balance cylinder Sold to Thailand

Release time:2023-11-17 13:21:07 Hits: Current position: Home > News

This article mainly introduces:

Thailand hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

Thailand tailboard balance cylinder

(Thailand tailboard balance cylinder,produced by Hengyu Group)

tailboard balance cylinder are widely used in Thailand,because of no transmission clearance,powerful torque,clever hydraulic energy conversion.So our company has designed tailboard balance cylinder for customers from Thailand.

Introduction to tailboard balance cylinder:

Before the tailboard balance cylinder is removed, the relief valve should be loosened to reduce the pressure of the hydraulic circuit to zero, and then the power supply should be cut off to stop the hydraulic device. After loosening the oil port piping, the oil plug should be applied to plug the oil port.

How to determine the working pressure of the tailboard balance cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, tailboard balance cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

tailboard balance cylinders in series, parallel and series parallel. Series: In the tailboard balance cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the tailboard balance cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the tailboard balance cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the tailboard balance cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

The definition of the minimum stable speed refers to the minimum movement speed of the tailboard balance cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the tailboard balance cylinder that undertakes different work has different requirements for the minimum stable speed.

Answers to some questions about tailboard balance cylinder:

Can pneumatic cylinder be used as hydraulic cylinder?
The pneumatic cylinder can only be used for pressure below 1MPA, and if it is used for hydraulic, the pressure should be under 1MPA, which may not meet the strength requirements. And the seals should use fluorine rubber to avoid corrosion. But pneumatic cylinder used as hydraulic cylinder is not whimsical, in fact, there is such a use. The pneumatic system has a natural defect, that is, the speed is unstable, especially in the case of low speed. The hydraulic pressure is very stable, if you do not want to buy a set of hydraulic system, while the strength of the cylinder is not large, you can use compressed air to push the hydraulic oil, with hydraulic oil to drive the cylinder, The force is the same as compressed air, but very smooth.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP
韩国福利精品视频| 17c超碰青青草原| 人人爽人人三级片| 美女少妇出轨网站| 操操操碰大鸡巴| 久久精品在中山| 91精品国产91久久久娜娜| 伊人大香蕉国产一区| 欧美大逼免费看| 亚洲另类激情图片| AⅤ观看导航网站| 欧美曰本韩国国产性爱www观看| 女优国产射了丝袜射了| 91男女私下视频| 日韩国产ac| www.日本一道视频在线| 日本黄色私人影院| 另类激情网站| 亚洲天堂bxbx久久| 美国黄色电影片久久久| 亞洲第一內射| 亚洲一级性感| 久久久综合视频88| 美女少妇一区二区| 无码色| 国产AV大香蕉久久| 日韩激情伦理av在线| 不卡av在线观看一区精品| 少妇尿久久久久久久| 欧美丝袜美腿图一区二区| 国产美女高超| 欧美日韩多人| 国产三级视频在线| av小说在线观看网址| 国产国语女教师3p高潮| 国产 亚洲 欧美 日韩 都市| 欧美大片内射美女区一| 激情亚洲图| 国产精品69毛片高清亚洲| 亚洲精品乱码久久久日本软件介绍| 大香蕉神马久久|